CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
Tech Tips
for Driver Side:
Operate the power seat switch to move the cushion length adjustment to the foremost position.
for Ottoman (Front Passenger Side):
Operate the power seat switch to move the ottoman to the foremost position.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)
REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)
REMOVE BATTERY SERVICE HOLE COVER LH
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE FRONT SEAT ASSEMBLY LH
REMOVE FRONT SEAT CUSHION SHIELD LH
REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD LH (for Driver Side)
REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD RH (for Front Passenger Side)
REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
REMOVE FRONT SEAT INNER CUSHION SHIELD LH
REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH
REMOVE FRONT SEAT CUSHION ASSEMBLY LH
REMOVE FRONT SEAT HEADREST ASSEMBLY
REMOVE FRONT SEAT HEADREST SUPPORT
REMOVE POWER SEAT SWITCH ASSEMBLY (w/ Shoulder Switch)
REMOVE FRONT SEATBACK COVER WITH PAD
REMOVE ACTIVE HEADREST INFLATOR (w/ Active Headrest)
REMOVE FRONT SEAT HEADREST ADJUSTER SUB-ASSEMBLY
w/ Active Headrest:
Detach the 2 wire harness clamps and disconnect the connector.
Remove the 2 bolts.
Detach the 2 claws and remove the headrest adjuster.
w/ Pre-crash Intelligent Headrest:
Detach the 2 wire harness clamps and disconnect the connector.
Detach the 4 wire harness clamps and remove the 2 bolts.
Detach the 2 claws and remove the headrest adjuster.
Remove the screw.
Detach the guide and remove the plate.
Detach the 2 claws and disconnect the connector from the connector holder.
w/ Retractable Headrest:
Remove the 2 screws and headrest motor from the seatback frame.
Remove the 4 bolts.
Detach the 2 claws and remove the headrest adjuster.
Detach the 2 claws and remove the motor.
Detach the 2 claws and remove the cable.
Remove the 2 screws and headrest stay cover.
REMOVE FRONT SEATBACK FRAME ASSEMBLY LH
REMOVE RECLINING ADJUSTER INSIDE COVER LH
REMOVE RECLINING ADJUSTER INSIDE COVER RH
REMOVE FRONT SEAT LOWER CUSHION SHIELD
REMOVE FRONT SEAT CUSHION SPRING
REMOVE NO. 1 SEAT CUSHION PLATE
REMOVE FRONT NO. 2 SEAT TRAVEL LINK
REMOVE FRONT NO. 1 SEAT TRAVEL LINK
REMOVE FRONT SEAT CLIMATE CONTROL ECU LH
REMOVE SEAT CLIMATE CONTROL BLOWER LH
REMOVE SEAT POSITION AIRBAG SENSOR
REMOVE FRONT SEAT WIRE LH
Remove the bolt.
Disconnect the 4 connectors.
Detach the 13 wire harness clamps to remove the front seat wire LH.