REAR SEAT ASSEMBLY(for Fixed Seat Type) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL BENCH TYPE REAR SEATBACK ASSEMBLY

    Note

    Be careful not to damage the vehicle body.


    1. Set the bench type rear seatback assembly in place.

    2. A000WOX

      Connect the rear center armrest assembly connector.

    3. Attach the 2 hooks on the backside of the bench type rear seatback assembly.

    4. Install the 4 bolts and nut.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }
    5. A000W8K

      w/ Seat Heater System:


      1. Connect the connector.

      2. Install the junction block with the bolt.

        Torque:
        30 N*m  { 306 kgf*cm, 22 ft.*lbf }
    6. A000YL5

      Attach the hook to the rear seat armrest hole board. Then attach the 2 clips to install the rear seat armrest hole board.

    7. A000WRG

      While pressing the button, raise the rear center seat headrest assembly.

    8. Raise the rear center armrest assembly.

    9. A000VLQ

      Connect the rear seat outer belt to the rear seat shoulder belt guide.

      Tech Tips

      Use the same procedure to connect the rear seat outer belt on the other side.

    10. Attach the 2 claws to close the 2 caps of the rear seat shoulder belt guide.

      Tech Tips

      Use the same procedure to close the 2 caps on the other side.

    11. A000WNF

      Connect the 2 seat belt anchors of the rear seat 3 point type belt assembly LH and rear seat 3 point type belt assembly RH with the 2 bolts and connect the seat belt anchor of the rear center seat outer belt assembly with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    Note

    Be careful not to damage the vehicle body.


    1. Set the bench type rear seat cushion assembly in place.

    2. A000YFWE02
      Text in Illustration
      *A w/ Seat Heater System

      w/ Seat Heater System:

      Connect the 2 connectors.

    3. Attach the 2 rear hooks of the bench type rear seat cushion assembly to the bench type rear seatback assembly.

    4. Attach the 3 front hooks to install the bench type rear seat cushion assembly.

    5. Confirm that the bench type rear seat cushion assembly is firmly installed.

      Note

      When installing the bench type rear seat cushion assembly, make sure the seat belt buckle is not under the bench type rear seat cushion assembly.

  3. CHECK SEAT HEATER SYSTEM (w/ Seat Heater System)

    Click here

  4. CHECK REAR SUNSHADE SYSTEM (w/ Sunshade)

    Click here