INSTRUMENT PANEL SAFETY PAD REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

    A000XGC

    1. Attach the 4 claws to install the No. 1 instrument panel register assembly.

  2. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

    A000ZL5

    1. Attach the 4 claws to install the No. 2 instrument panel register assembly.

  3. INSTALL NO. 1 METER HOOD RETAINER


    1. Install the 2 No. 1 meter hood retainers with the 2 screws.

  4. INSTALL NO. 1 INSTRUMENT PANEL PIN

    Tech Tips

    Use the same procedure to install the No. 1 instrument panel pin on the other side.


    1. Install the No. 1 instrument panel pin with the screw.

  5. INSTALL NO. 2 INSTRUMENT PANEL WIRE


    1. Attach the 5 wire harness clamps to install the No. 2 instrument panel wire.

  6. INSTALL AUTOMATIC LIGHT CONTROL SENSOR

    A000VK3

    1. Attach the 2 claws to install the automatic light control sensor.

    2. Connect the connector.

  7. INSTALL NAVIGATION ANTENNA ASSEMBLY

    Click here

  8. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY

    Click here

  9. INSTALL NO. 2 INSTRUMENT PANEL WIRE

    Click here

  10. INSTALL ION GENERATOR SUB-ASSEMBLY

    Click here

  11. INSTALL NO. 2 HEATER TO REGISTER DUCT


    1. Install the No. 2 heater to register duct with the 2 screws.

    2. Connect the hose to the ion generator sub-assembly.

  12. INSTALL DEFROSTER NOZZLE ASSEMBLY


    1. Install the defroster nozzle assembly with the 3 screws.

  13. INSTALL NO. 3 HEATER TO REGISTER DUCT


    1. Install the No. 3 heater to register duct with the 3 screws.

  14. INSTALL NO. 1 HEATER TO REGISTER DUCT


    1. Install the No. 1 heater to register duct with the 3 screws.

  15. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT


    1. Attach the claw to install the No. 2 side defroster nozzle duct.

    2. Install the screw.

  16. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT


    1. Attach the claw to install the No. 1 side defroster nozzle duct.

    2. Install the screw.

  17. INSTALL NO. 1 COMBINATION METER BRACKET


    1. Install the No. 1 combination meter bracket.