CAUTION / NOTICE / HINT
Tech Tips
Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)
REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)
REMOVE BATTERY SERVICE HOLE COVER LH
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
w/o Rear Door Sunshade:
Remove rear door trim board sub-assembly LH Click here.
w/ Rear Door Sunshade:
Remove rear door trim board sub-assembly LH Click here.
REMOVE REAR DOOR TRIM COVER LH
REMOVE REAR DOOR FRAME GARNISH LH
REMOVE REAR DOOR NO. 2 FRAME GARNISH LH
REMOVE REAR CURTAIN SUB-ASSEMBLY LH (w/ Rear Door Sunshade)
REMOVE NO. 1 AUTO CURTAIN RAIL BRACKET LH (w/ Rear Door Sunshade)
REMOVE REAR SIDE TRIM BOARD COVER LH (w/ Rear Door Sunshade)
REMOVE REAR DOOR GLASS INNER WEATHERSTRIP LH
REMOVE REAR DOOR SERVICE HOLE COVER LH
REMOVE REAR DOOR DIVISION BAR LOWER BRACKET LH
REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
REMOVE REAR DOOR GLASS RUN LH
REMOVE REAR DOOR QUARTER WINDOW GLASS LH
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 ''TORX'' driver, remove the 3 screws and rear power window regulator motor assembly.
Note
Be careful when removing the screws as the motor may fall and become damaged.