POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. A000Z8Y

      Apply MP grease to the sliding and rotating areas of the regulator motor.

    2. Using a T25 ''TORX'' driver, install the motor with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  4. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  5. INSTALL DOOR FRAME GARNISH LH

    Click here

  6. INSTALL FRONT DOOR TRIM COVER LH

    Click here

  7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  8. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for LHD)


    1. A000X1O

      Connect the connector.

    2. Install the power window regulator master switch assembly.

  9. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for RHD)


    1. A000XEG

      Connect the 2 connectors.

    2. Install the front power window regulator switch assembly.

  10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  12. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  13. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  14. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  15. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.