CAUTION / NOTICE / HINT
Tech Tips
Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)
REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)
REMOVE BATTERY SERVICE HOLE COVER LH
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for LHD)
Using a screwdriver, disengage the 2 clips.
Tech Tips
Tape the screwdriver tip before use.
Disconnect the connector and remove the power window regulator master switch assembly.
REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for RHD)
Using a screwdriver, disengage the 2 clips.
Tech Tips
Tape the screwdriver tip before use.
Disconnect the 2 connectors and remove the front power window regulator switch assembly.
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
REMOVE FRONT DOOR TRIM COVER LH
REMOVE DOOR FRAME GARNISH LH
REMOVE FRONT DOOR SERVICE HOLE COVER LH
REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" driver, remove the 3 screws and motor.
Note
Be careful when removing the screws as the motor may fall and become damaged.