OUTER REAR VIEW MIRROR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH


    1. Install the outer rear view mirror assembly LH with the 3 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Attach the 3 clamps.

  2. INSTALL FRONT DOOR NO. 2 SERVICE HOLE COVER LH

    Click here

  3. INSTALL MULTIPLEX NETWORK FRONT DOOR ECU LH

    Click here

  4. INSTALL DOOR FRAME GARNISH LH

    Click here

  5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  6. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  10. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  11. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  12. INSTALL COWL TOP VENTILATOR LOUVER RH (w/ Spare Tire)

    Click here