DRIVER MONITOR ECU(for LHD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL DRIVER MONITOR ECU ASSEMBLY


    1. Install the driver monitor ECU assembly with the nut.

    2. Install the ECU unit with the 2 nuts.

      Torque:
      8.5 N*m  { 86 kgf*cm, 75 in.*lbf }

    3. Connect the 3 connectors.

  2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  5. INSTALL INSTRUMENT PANEL ORNAMENT

    Click here

  6. INSTALL INSTRUMENT SIDE PANEL LH

    Click here

  7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  9. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  10. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  11. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  12. CHECK SRS WARNING LIGHT

    Click here