PRE-CRASH BRAKE CANCEL SWITCH INSPECTION

PROCEDURE


  1. INSPECT PRE-CRASH SYSTEM CANCEL SWITCH ASSEMBLY

    A000VD7E05
    *1 Component without harness connected: (Pre-crash System Cancel Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 (GND) - 2 (ECU) Pre-crash system cancel switch pushed Below 1 Ω
      1 (GND) - 2 (ECU) Pre-crash system cancel switch not pushed 10 kΩ or higher

      If the result is not as specified, replace the pre-crash system cancel switch assembly.