PRE-CRASH SAFETY SYSTEM DIAGNOSIS SYSTEM


  1. INITIAL CHECK


    1. 2 seconds or more after turning the power switch OFF, turning the power switch ON (IG) causes the pre-crash safety system to perform an initial check for approximately 3 seconds.

    2. If a malfunction is detected in the initial check, after the 3 second initial check, the combination meter assembly's multi-information display displays "Check PCS System".

      Tech Tips

      "Check PCS System" is displayed when a pre-crash safety system malfunction has been detected and a DTC is output.

  2. CONSTANT CHECK


    1. After the 3 second initial check, the seat belt control ECU and driving support ECU control the system, and perform a constant check to monitor the system.

    2. If a malfunction is detected in the constant check, the combination meter assembly's multi-information display displays "Check PCS System" or "PCS not available now".

      Tech Tips

      "PCS not available now" is displayed during the following conditions: 1) the seat belt control ECU's overheat protection function has operated; 2) due to bad weather, the radar cannot detect obstacles; 3) foreign matter is attached to the grille cover or front millimeter wave radar sensor assembly; or 4) foreign matter is attached to the rear bumper or rear millimeter wave radar sensor assembly.

      A000WEZE06
      *1 Turn power switch ON (IG)
      *2 Approximately 3 second Initial Check
      *3 Turn power switch OFF
      *4 Constant Check