FRONT AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL FRONT AIRBAG SENSOR LH


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A000V5L

      Connect the connector.

    4. Install the front airbag sensor LH with the 2 bolts.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    5. Check that there is no looseness in the installation parts of the front airbag sensor.

  2. INSTALL HEADLIGHT ASSEMBLY LH

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  5. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  6. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  7. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  8. CHECK SRS WARNING LIGHT

    Click here