CENTER AIRBAG SENSOR ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing Click here.

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

   Click here

3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

   Click here

4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

   Click here

5. REMOVE BATTERY SERVICE HOLE COVER LH

   Click here

6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

7. REMOVE CONSOLE BOX ASSEMBLY

   
   

   1. for 5-Passenger with Ottoman:

      Click here

   2. w/o Rear Seat Entertainment System:

      Click here

   3. w/ Disc Player:

      Click here

8. REMOVE CENTER AIRBAG SENSOR ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      Push and pull the connector lock lever to release the connector lock as shown in the illustration.

      Note

      When disconnecting airbag connector, take care not to damage the airbag wire harness.

   4. Remove the 3 bolts and center airbag sensor assembly.