CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A000XGFE03
      Text in Illustration
      *1 Waterproof Sheet

      Install the center airbag sensor assembly with the 3 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

      Note


      • If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the power switch is first turned on (IG) after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

    4. Connect the connector to the center airbag sensor assembly as shown in the illustration.

      Note

      When connecting airbag connector, take care not to damage the airbag wire harness.

    5. Check that the waterproof sheet is properly set.

    6. Check that there is no looseness in the installation parts of the center airbag sensor assembly.

  2. INSTALL CONSOLE BOX ASSEMBLY


    1. for 5-Passenger with Ottoman:

      Click here

    2. w/o Rear Seat Entertainment System:

      Click here

    3. w/ Disc Player:

      Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. CHECK SRS WARNING LIGHT

    Click here

  5. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  6. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  7. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  8. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here