DRIVER SIDE KNEE AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      Connect the airbag connector.

      Note

      When connecting airbag connector, take care not to damage the airbag wire harness.

   4. Push in the lock to connect the airbag connector.

   5. Attach the claw to connect the hood lock control lever sub-assembly to the driver side knee airbag assembly.

   6. Attach the clip to install the driver side knee airbag assembly.

   7. Install the 4 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the driver side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

4. INSTALL INSTRUMENT PANEL ORNAMENT

   Click here

5. INSTALL INSTRUMENT SIDE PANEL LH

   Click here

6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

   Click here

7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

8. CHECK SRS WARNING LIGHT

   Click here

9. INSTALL BATTERY SERVICE HOLE COVER LH

   Click here

10. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

11. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

12. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here