SPIRAL CABLE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  5. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  6. DISABLE AUTOAWAY/RETURN FUNCTION


    1. Disable the auto away/return function by changing the customize parameter Click here.

      CAUTION:

      Record the current customize parameter setting (whether the auto away/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation disables the auto away/return function when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the power switch off.

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  9. REMOVE STEERING COLUMN COVER


    1. w/o Driver Monitor Camera:

      Click here

    2. w/ Driver Monitor Camera:

      Click here

  10. REMOVE SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR

    Note


    • Do not replace the spiral cable sub-assembly with the auxiliary battery connected and the power switch on (IG).

    • Do not rotate the spiral cable sub-assembly with the auxiliary battery connected and the power switch on (IG).

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


    1. A000ZHOE02
      Text in Illustration
      *1 Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable sub-assembly with sensor.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    2. Disconnect the other connector from the spiral cable sub-assembly with sensor.

    3. A000WIS

      Detach the 3 claws to remove the spiral cable sub-assembly with sensor.

  11. REMOVE STEERING SENSOR

    A000XSM

    1. Detach the 6 claws to remove the spiral cable subassembly from the steering sensor.