STEERING PAD INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

INSTALL STEERING PAD
1. Check that the power switch is off.
2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
3. Connect the horn connector to the steering pad.
4. Connect the 2 airbag connectors to the steering pad.
  Note
  - When connecting airbag connector, take care not to damage the airbag wire harness.
  - Be sure to only connect the connectors to each corresponding color.
  Text in Illustration
  
  *a Orange
  
  *b Black
5. Push in the 2 airbag connector locks to connect the 2 airbag connectors.
6. Push the steering pad to attach the 3 pins carefully.
  Note
  
  Make sure that the pins are securely inserted into the steering holes.
  
  Make sure to attach the 2 upper pins first.
  
  Make sure that the steering pad is securely installed.
INSTALL LOWER NO. 2 STEERING WHEEL COVER
1. Attach the claw to install the lower No. 2 steering wheel cover.
INSTALL LOWER NO. 3 STEERING WHEEL COVER
1. Attach the claw to install the lower No. 3 steering wheel cover.
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSPECT STEERING PAD
1. Make sure that the horn sounds.
  
  Tech Tips
  
  If the horn does not sound, inspect the horn system Click here.
CHECK SRS WARNING LIGHT

Click here
INSTALL BATTERY SERVICE HOLE COVER LH

Click here
INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

Click here
INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

Click here
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

Click here

Text in Illustration
*a	Orange
*b	Black