NIGHT VIEW CAMERA INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL OBJECT RECOGNITION WITH NIGHT VIEW CAMERA

    Note


    • Do not touch the camera lens when removing or installing the camera.

    • Do not use a camera which has been dropped or subjected to an impact.

    • If the camera is not installed securely, the system may not operate properly. Therefore, be sure to install the camera securely.

    • Push the bracket to attach the clip.

    • Allow the wire harness to hang down.

    • Do not press the sensor, as it may become deformed.


    1. A000WG6E02

      Temporarily install the object recognition with night view camera with the clip.

    2. Install the 3 bolts in alphabetical order.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

    3. Attach the claw to connect the connector clamp.

    4. Attach the 2 wire harness clamps.

    5. Connect the 3 connectors.

    6. Return the roof headlining to its original position.

  2. INSTALL INNER REAR VIEW MIRROR ASSEMBLY


    1. w/o Automatic High Beam System, Adaptive High Beam System:

      Click here

    2. w/ Automatic High Beam System, Adaptive High Beam System:

      Click here

  3. INSTALL RAIN SENSOR COVER

    Click here

  4. INSTALL VISOR HOLDER

    Click here

  5. INSTALL VISOR ASSEMBLY LH

    Click here

  6. INSTALL VISOR ASSEMBLY RH

    Click here

  7. INSTALL VISOR BRACKET COVER

    Click here

  8. INSTALL MAP LIGHT ASSEMBLY

    Click here

  9. ADJUST OBJECT RECOGNITION CAMERA

    Click here

  10. ADJUST NIGHT VIEW CAMERA

    Click here