ULTRASONIC SENSOR(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

Note

When replacing the sensor, only replace the clips and sensor.

PROCEDURE


  1. REMOVE REAR BUMPER COVER

    Click here

  2. REMOVE NO. 3 LUGGAGE ROOM WIRE

    Click here

  3. REMOVE NO. 1 ULTRASONIC SENSOR


    1. A000ZXI

      Remove the sensors from the 4 sensor retainers as shown in the illustration.

      Note


      • Be careful not to damage the retainer.

      • Do not forcibly remove the retainer from the bumper cover.

  4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    1. A000WCJ

      While heating the retainer using a dryer, pull the retainer lightly and remove the double-sided tape. Then remove the retainer.

      Heating temperature
      40 to 60°C (104 to 140°F)

      CAUTION:

      Be careful of burns.

    2. Using a cloth or non-residue solvent, wipe off any tape residue on the bumper cover.