CLEARANCE WARNING ECU REMOVAL

PROCEDURE

1. PRECAUTION

   CAUTION:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

   Click here

3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

   Click here

4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

   Click here

5. REMOVE BATTERY SERVICE HOLE COVER LH

   Click here

6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

7. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for RHD)

   Click here

8. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)

   Click here

9. REMOVE INSTRUMENT SIDE PANEL LH (for RHD)

   Click here

10. REMOVE INSTRUMENT SIDE PANEL RH (for LHD)

    Click here

11. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

12. REMOVE LOWER INSTRUMENT PANEL

    Click here

13. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

    Click here

14. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

15. REMOVE CLEARANCE WARNING ECU ASSEMBLY

    
    

    1. for LHD:

       
       

       1. 

          Remove the bolt and nut.

       2. Disconnect each connector and remove the ECU integration bracket.

          Note

          Do not forcibly disconnect the connector.

       3. 

          Remove the nut.

       4. Detach the guide and remove the clearance warning ECU assembly.

          Note

          
          

          • Avoid any impact to the clearance warning ECU.

          • Do not drop the ECU. If it is dropped, replace it with a new one.

    2. for RHD:

       
       

       1. 

          Remove the bolt and nut.

       2. Disconnect each connector and remove the ECU integration bracket.

          Note

          Do not forcibly disconnect the connector.

       3. 

          Remove the nut and clearance warning ECU assembly.

          Note

          
          

          • Avoid any impact to the clearance warning ECU.

          • Do not drop the ECU. If it is dropped, replace it with a new one.