| DTC Code | DTC Name |
|---|---|
| B281A | Camera not Adjusted |
DESCRIPTION
If the power switch is turned on (IG) after replacing the No. 1 night view ECU or object recognition camera (night view camera) without performing object recognition camera (night view camera) adjustment, a DTC is stored. When object recognition camera (night view camera) adjustment is completed successfully, the DTC is cleared automatically.
Tech Tips
While DTCs are stored, the night view system does not operate and a warning message is displayed on the accessory meter assembly.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B281A | The power switch is turned on (IG) without performing object recognition camera (night view camera) adjustment. |
|
CAUTION / NOTICE / HINT
Note
When the No. 1 night view ECU is replaced, perform object recognition camera (night view camera) adjustment (See page ). Click here
PROCEDURE
ADJUST OBJECT RECOGNITION CAMERA (NIGHT VIEW CAMERA) (MANUAL ADJUSTMENT)
Using the GTS, perform manual object recognition camera (night view camera) adjustment Click here.
| Result | Proceed to |
|---|---|
| Manual adjustment can be performed | A |
| Manual adjustment cannot be performed (When manual adjustment cannot be performed even after checking the camera installation and the target position) | B |
| B |
|
REPLACE NO. 1 NIGHT VIEW ECU Click here |
| A |
|
CHECK FOR DTC
Clear the DTCs Click here.
Turn the power switch off.
Wait 6 seconds after turning the power switch off, and then turn the power switch on (IG).
Check for DTCs Click here.
Tech Tips
When adjustment is performed again, DTC B280A may be stored. However, as this does not indicate a malfunction, clear the DTCs.
| OK |
|---|
| No DTCs are output. |
| OK |
|
END (OBJECT RECOGNITION CAMERA [NIGHT VIEW CAMERA] ADJUSTMENT IS DEFECTIVE) |
| NG |
|
REPLACE NO. 1 NIGHT VIEW ECU Click here |