HARD DISK DRIVE REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • Precautions for multi-media module receiver assembly and hard disc Click here.

    CAUTION:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  5. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

    Click here

  8. REMOVE NO. 2 RADIO BRACKET

    Click here

  9. REMOVE HARD DISC


    1. A000YFH

      Remove the 2 screws.

    2. Detach the 2 claws and remove the cover.

    3. A000TZP

      Remove the hard disc in the direction of the arrow shown in the illustration.