DIGITAL AUDIO BROADCASTING ANTENNA INSTALLATION

PROCEDURE


  1. INSTALL AMPLIFIER ANTENNA ASSEMBLY NO.2


    1. Use non-residue solvent to clean the area on the glass where the antenna will be installed.

      Note

      Do not use non-residue solvent to clean the antenna's contact points. Doing so may cause improper contact between the antenna and glass.

    2. Install the amplifier antenna assembly with the 2 nuts.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

      Note


      • Just before installing the antenna to the glass, remove the protective cover of the antenna's contact points.

      • When removing the protective cover of the antenna's contact points, make sure the cover does not touch the contact points.

      • Never touch the contact points after removing the protective cover.

      Tech Tips


      • A000ZZSE02

        Do not reuse the plate if damaged heavily.

      • The plate is used when the vehicle is assembled at the factory. Therefore the antenna performance is not affected by not reusing it.

        Text in Illustration
        *1 Plate

    3. Attach the 2 clamps.

    4. Connect the connector and install the amplifier antenna assembly.

  2. INSTALL ROOF HEADLINING ASSEMBLY


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  5. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  6. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  7. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here