NETWORK GATEWAY ECU(for RHD) REMOVAL

PROCEDURE

1. PRECAUTION

   CAUTION:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

   Click here

3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

   Click here

4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

   Click here

5. REMOVE BATTERY SERVICE HOLE COVER LH

   Click here

6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

7. REMOVE INSTRUMENT PANEL ORNAMENT

   Click here

8. REMOVE INSTRUMENT SIDE PANEL RH

   Click here

9. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

10. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

11. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

12. REMOVE NETWORK GATEWAY ECU

    
    

    1. 

       Disconnect each connector.

    2. 

       Remove the 2 nuts and No. 1 ECU integration bracket.

    3. 

       Remove the 2 nuts and network gateway ECU.