REAR SEAT ENTERTAINMENT SYSTEM Disc Player Controller Power Source Circuit

DESCRIPTION

This is the power source circuit of the disc player assembly.

WIRING DIAGRAM

A000THYE11

CAUTION / NOTICE / HINT

Note

Inspect the fuses and relays for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (DISC PLAYER ASSEMBLY - BATTERY AND BODY GROUND)


    1. A000YGBE01
      Text in Illustration
      *A for 4-passenger with Ottoman
      *B except 4-passenger with Ottoman
      *a

      Front view of wire harness connector

      (to Disc Player Assembly)

      Disconnect the disc player assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for 4-passenger with Ottoman
      Tester Connection Condition Specified Condition
      z95-13 (GND) - Body ground Always Below 1 Ω
      except 4-passenger with Ottoman
      Tester Connection Condition Specified Condition
      R98-13 (GND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      for 4-passenger with Ottoman
      Tester Connection Switch Condition Specified Condition
      z95-8 (+B) - Body ground Power switch off 11 to 14 V
      z95-7 (ACC) - Body ground Power switch on (ACC) 11 to 14 V
      except 4-passenger with Ottoman
      Tester Connection Switch Condition Specified Condition
      R98-8 (+B) - Body ground Power switch off 11 to 14 V
      R98-7 (ACC) - Body ground Engine switch on (ACC) 11 to 14 V

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR