AUDIO AND VISUAL SYSTEM Visual Mute Signal Circuit between Radio Receiver and Multi-display

DESCRIPTION

The multi-media module receiver assembly sends a visual mute signal to the accessory meter assembly. As a result, a black screen is inserted when the screen changes so that noise and distorted images are not displayed.

When an open exists in the circuit, noise and distorted images will be displayed instead of a black screen.

When a short exists in the circuit, even though the accessory meter assembly is operating normally, noise and distorted images will be displayed (black screen will not be displayed) during screen changes or the black screen will always be displayed.

WIRING DIAGRAM

A000ZWLE91
*1 VMTI
*2 VMTF
*3 Accessory Meter Assembly
*4 Multi-media Module Receiver Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - ACCESSORY METER ASSEMBLY)


    1. Disconnect the L164 multi-media module receiver assembly connector.

    2. Disconnect the L163 accessory meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L164-10 (VMTF) - L163-11 (VMTI) Always Below 1 Ω
      L164-10 (VMTF) or L163-11 (VMTI) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY


    1. A000WERE01
      Text in Illustration
      *a

      Component with harness connected

      (Multi-media Module Receiver Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L164-10 (VMTF) - Body ground Power switch on (ACC), screen display changes 3.5 V or higher → Below 1 V → 3.5 V or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here