HEATED STEERING WHEEL CONTROLLER REMOVAL

PROCEDURE

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

   Click here

2. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

   Click here

3. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

   Click here

4. REMOVE BATTERY SERVICE HOLE COVER LH

   Click here

5. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

7. REMOVE STEERING WHEEL ASSEMBLY

   Click here

8. REMOVE STEERING PAD SWITCH ASSEMBLY

   Click here

9. REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY

   Click here

10. REMOVE STEERING WHEEL BOSS COVER LOWER

    Click here

11. REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY

    
    

    1. 

       Disconnect the connector clamp and remove the 2 screws and heater control assembly.