STEERING WHEEL REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column Click here.

Tech Tips


  • Use the same procedures for the RHD and LHD.

  • The procedures listed below are for the LHD.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  2. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  3. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  4. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  5. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE STEERING PAD ASSEMBLY

    Click here

  8. REMOVE STEERING WHEEL ASSEMBLY


    1. A000XBZE03
      Text in Illustration
      *a Matchmark
      *b Hold
      *c Turn

      Remove the steering wheel set nut.

    2. Put matchmarks on the steering wheel and main shaft.

    3. Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05011 )

  9. REMOVE STEERING PAD SWITCH ASSEMBLY


    1. A000X9A

      Disconnect the connector clamp.

    2. A000XVG

      Remove the 4 screws.

    3. Detach the 6 guides remove the steering pad switch assembly.

  10. REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY

    Click here

  11. REMOVE CRUISE CONTROL SWITCH WIRE

  12. REMOVE STEERING WHEEL BOSS COVER LOWER


    1. A000WCN

      w/o Shift Paddle Switch:

      Remove the 2 screws, 2 guide pins and 2 claws of the steering wheel boss lower cover.

    2. A000U5B

      w/ Shift Paddle Switch:

      Remove the 4 screws and 2 claws of the steering wheel boss lower cover.

  13. REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)


    1. A000YB0

      Disconnect the connector clamp and remove the 2 screws and heater control assembly.

  14. REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)

    Click here

  15. REMOVE STEERING SHAKE DAMPER


    1. A000VIU

      Remove the 2 screws and steering shake damper.