STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL STEERING SHAKE DAMPER

   
   

   1. Install the shake damper with the 2 screws.

2. INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)

   Click here

3. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)

   
   

   1. Install the heater control assembly with the 2 screws and connect the connector clamp.

4. INSTALL STEERING WHEEL BOSS COVER LOWER

   
   

   1. w/o Shift Paddle Switch:

      Attach the 2 guide pins, 2 claws and 2 screws to install the steering wheel lower cover.

   2. w/ Shift Paddle Switch:

      Attach the 2 claws and a new 4 screws to install the steering wheel lower cover.

5. INSTALL CRUISE CONTROL SWITCH WIRE

6. INSTALL CRUISE CONTROL MAIN SWITCH ASSEMBLY

   Click here

7. INSTALL STEERING PAD SWITCH ASSEMBLY

   
   

   1. Install the steering pad switch with the 4 screws and connect the 6 guide pins.

   2. Connect the connector clamp.

8. INSTALL STEERING WHEEL ASSEMBLY

   
   

   1. Align the matchmarks on the steering wheel assembly and steering main shaft assembly.

   2. Connect the connectors.

   3. Install the steering wheel assembly set nut.

      Torque:

      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

9. INSTALL STEERING PAD ASSEMBLY

   Click here

10. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

11. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

12. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

13. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

14. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

15. CHECK SRS WARNING LIGHT

    Click here