POWER STEERING ECU INSTALLATION

PROCEDURE


  1. INSTALL POWER STEERING ECU


    1. A000TZO

      Attach the claw and install the ECU with the 4 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    2. Connect the connector C to the ECU.

      A000U45E01

    3. Connect the ECU connectors A and B and securely lock the connectors.

  2. INSTALL NO. 1 INVERTER RESERVOIR BRACKET


    1. A000XZZ

      Install the bracket with the 2 bolts.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }
    2. A000W6C

      Install the reservoir with the 2 nuts.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  3. INSTALL AIR CLEANER ASSEMBLY RH

    Click here

  4. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY


    1. Install the inlet cover with the 5 clips.

  5. INSTALL ENGINE ROOM SIDE COVER

    Click here

  6. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  8. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  9. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

  10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  11. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION

    Click here