ELECTRIC PARKING BRAKE ACTUATOR REMOVAL

PROCEDURE


  1. RELEASE PARKING BRAKE


    1. With the power switch ON (IG), operate the electric parking brake switch to release the parking brake. Then turn the power switch OFF.

      Tech Tips

      If the parking brake cannot be released, use the luggage compartment's parking brake release tool to manually release the parking brake (refer to the Owner's Manual).

  2. REMOVE REAR WHEEL

  3. REMOVE SEAT VIBRATOR MODULE ASSEMBLY (for Ottoman)

    Click here

  4. DISCONNECT ELECTRIC PARKING BRAKE ACTUATOR CONNECTOR


    1. A000Z96

      Detach the trunk interior's electric parking brake actuator grommet and disconnect the connector.

  5. REMOVE REAR ACTIVE STABILIZER CONTROL ECU ASSEMBLY (w/ Active Stabilizer System)

    Click here

  6. REMOVE REAR WHEEL HOUSE LINER LH

    Click here

  7. DISCONNECT WIRE HARNESS CLAMP


    1. A000VHX

      Disconnect the 2 clamps shown in the illustration.

  8. REMOVE FLOOR NO. 1 UNDER COVER

    Click here

  9. DISCONNECT PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

    Click here

  10. REMOVE ELECTRIC PARKING BRAKE ACTUATOR CAP


    1. A000Y7K

      Remove the actuator cap and 2 nuts.

  11. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here

  12. DISCONNECT PARKING BRAKE CABLE

    Click here

  13. REMOVE PARKING BRAKE WITH BRACKET ACTUATOR ASSEMBLY


    1. A000TGW

      Remove the bolt and 5 nuts.

    2. Detach the clamp from the member.

    3. A000W3Q

      Remove the 3 harness clamps from the member.

    4. A000ZPU

      Remove the 3 nuts and actuator.