BRAKE PEDAL SUPPORT(for LHD) REMOVAL

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read the Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  5. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  8. DISCONNECT CONNECTORS


    1. A000Z4X

      Disconnect the brake pedal stroke sensor connector.

    2. Disconnect the stop light switch connector, and then detach the wire harness clamp.

  9. REMOVE BRAKE PEDAL RETURN SPRING


    1. A000Z12

      Remove the spring.

  10. REMOVE PUSH ROD PIN


    1. A000W69E01
      Text in Illustration
      *1 Push Rod Pin
      *2 Clip

      Remove the clip and push rod pin.

  11. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. A000XW0

      Remove the 4 nuts.

    2. A000Y19E01
      Text in Illustration
      *1 Brake Pedal Support

      Remove the 2 bolts and brake pedal support.