BRAKE CONTROL POWER SUPPLY INSTALLATION

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET


    1. A000XX7

      Install the 2 brackets with the 4 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not drop the brake control power supply. If the brake control power supply has been dropped, replace the brake control power supply with a new one.

  2. INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY


    1. A000TH5

      Connect the connector to the brake control power supply.

    2. Install the brake control power supply with the 2 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH

    Click here

  4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  6. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  7. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  8. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  9. CHECK AND CLEAR DTC

    Click here