SKID CONTROL BUZZER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicles.

Note

While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL SKID CONTROL BUZZER ASSEMBLY

    Note

    If the buzzer connector is connected with the buzzer installed to the vehicle, the clamp of the buzzer may be damaged. Make sure to install the buzzer according to the procedures below.


    1. Connect the connector.

    2. A000Y4Z

      Attach the clamp and install the buzzer to the extension panel.

  2. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note


    • Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  5. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  6. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  7. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here