SKID CONTROL ECU(for LHD) INSTALLATION

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL SKID CONTROL ECU BRACKET


    1. A000YB8E02
      Text in Illustration
      *a Front

      Install the bracket with the bolt and 2 nuts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

  2. CONNECT BRAKE FLUID RESERVOIR


    1. A000U4G

      Install the brake fluid reservoir with the 2 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

  3. CONNECT NO. 3 RELAY BLOCK

    Click here

  4. INSTALL SKID CONTROL ECU


    1. A000TP7E02

      Connect the 2 connectors (labeled A) and press the lock levers down to lock the connectors (labeled B).

      Note

      Make sure that the lock levers securely lock the connectors.

    2. Connect the connector.

    3. A000VI1E08
      Text in Illustration
      *a Front

      Install the ECU with the 2 bolts and nut.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    4. Connect the short connector for the brake stroke simulator to the bracket of the skid control ECU.

  5. CONNECT NO. 1 MOTOR COOLING PIPE


    1. A000XGJ

      Connect the No. 1 motor cooling pipe with the bolt.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  6. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  8. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  9. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  11. CHECK AND CLEAR DTC

    Click here

  12. PERFORM LINEAR VALVE OFFSET LEARNING

    Click here

  13. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

    Click here

  14. PERFORM TEST MODE INSPECTION

    Click here

  15. INSTALL ENGINE ROOM SIDE COVER LH

    Click here

  16. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here