BRAKE PEDAL STROKE SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the LHD vehicles.

Note

While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

Click here
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

Click here
REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

Click here
REMOVE BATTERY SERVICE HOLE COVER LH

Click here
PRECAUTION

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
1. Disable the AUTO TILT AWAY function by changing the customize parameter Click here.
  
  Note
  
  Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.
2. Turn the power switch ON (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.
3. Turn the power switch OFF and disconnect the cable from the negative (-) battery terminal.
  
  Note
  
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here
REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY
1. Disconnect the sensor connector.
2. Remove the 2 bolts and sensor.
  
  Note
  
  Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.