STEERING ANGLE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL STEERING SENSOR


    1. A000UCOE01
      Text in Illustration
      *1 Pin

      Align the pins on the spiral cable with the installation holes on the steering sensor.

    2. Attach the 6 claws and install the steering sensor to the spiral cable.

  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY

    Click here

  3. INSTALL STEERING COLUMN COVER

    Click here

  4. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note


    • Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter Click here.

    • When reconnecting the cable to the negative battery terminal after installing the steering sensor, check that the front tires and steering wheel are kept aligned straight ahead before and after connecting the cable to the negative battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSPECT STEERING PAD

    Click here

  7. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  8. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  9. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  11. CHECK SRS WARNING LIGHT

    Click here