STEERING ANGLE SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE

PRECAUTION

CAUTION:

Be sure to read the Precaution thoroughly before servicing Click here.

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

Click here
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

Click here
REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

Click here
REMOVE BATTERY SERVICE HOLE COVER LH

Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
1. Disable the AUTO TILT AWAY function by changing the customize parameter Click here.
  
  Note
  
  Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.
2. Turn the power switch ON (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.
3. Turn the power switch OFF and disconnect the cable from the negative (-) battery terminal.
  
  Note
  
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
REMOVE STEERING WHEEL ASSEMBLY

Click here
REMOVE STEERING COLUMN COVER

Click here
REMOVE SPIRAL CABLE SUB-ASSEMBLY

Click here
REMOVE STEERING SENSOR
1. Detach the 6 claws and remove the steering sensor.