REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • The procedures listed below are for the RH side.

  • Other than areas where instructions are provided, use the same procedures for the LH side and RH side.

Note

While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL REAR SPEED SENSOR RH


    1. A000V1I

      Install the sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • The speed sensor is easily damaged. When installing the speed sensor to the axle hub, do not use excessive force to rotate and install it.

      • Prevent foreign matter from attaching to the sensor tip.

      • Do not drop the sensor. If the sensor has been dropped replace the sensor with a new one.

  2. INSTALL SKID CONTROL SENSOR WIRE


    1. A000V6X

      Connect the rear speed sensor connector.

    2. Connect the pad wear indicator connector.

    3. Install the sensor clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamps.

    4. A000ZV6

      Install the 2 sensor clamps with the 2 nuts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    5. Connect the rear height control sensor connector.

    6. A000WIX

      Insert the connector and grommet to the inside of the vehicle through the hole in the wheel house.

    7. for RH:


      1. A000Y10

        Connect the skid control sensor wire connector to the vehicle side connector.

    8. for LH:


      1. A000ZCR

        Connect the skid control sensor wire connector to the vehicle side connector.

  3. INSTALL REAR WHEEL

    Torque:
    140 N*m  { 1428 kgf*cm, 103 ft.*lbf }

  4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH

    Click here

  5. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Click here

  6. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  8. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  9. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  11. CHECK SPEED SENSOR SIGNAL

    Click here