FRONT SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • The procedures listed below are for the RH side.

  • Use the same procedures for the LH side and RH side.

Note

While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL FRONT SPEED SENSOR RH


    1. A000VY3

      Install the sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • The speed sensor is easily damaged.

        When installing the speed sensor to the axle hub, do not use excessive force to rotate and install it.

      • Prevent foreign matter from attaching to the sensor tip.

      • Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.

  2. INSTALL SKID CONTROL SENSOR WIRE


    1. A000XRV

      Connect the connector to the front speed sensor.

    2. Install the sensor clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    3. Connect the pad wear indicator connector.

    4. A000TPS

      Install the 2 sensor clamps with the 2 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamps.

    5. A000TNVE03
      Text in Illustration
      *1 Fender Liner

      Attach the 2 sensor clips.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamp.

    6. Connect the sensor connector.

    7. Connect the front fender liner.

  3. INSTALL FRONT WHEEL

    Torque:
    140 N*m  { 1428 kgf*cm, 103 ft.*lbf }

  4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  6. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  7. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  8. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  9. CHECK SPEED SENSOR SIGNAL

    Click here