FRONT SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • The procedures listed below are for the RH side.

  • Use the same procedures for the LH side and RH side.

Note

While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  2. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  3. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  4. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  5. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE FRONT WHEEL

  8. REMOVE SKID CONTROL SENSOR WIRE


    1. A000TNVE03
      Text in Illustration
      *1 Fender Liner

      Disconnect the front fender liner so that the skid control sensor wire connector can be disconnected.

    2. Disconnect the sensor connector.

    3. Detach the 2 sensor clips.

    4. A000XHT

      Remove the 2 bolts and 2 sensor clamps.

    5. A000XJG

      Disconnect the pad wear indicator connector.

    6. Disconnect the connector from the front speed sensor.

    7. Remove the bolt and sensor clamp.

  9. REMOVE FRONT SPEED SENSOR RH


    1. A000VY3

      Remove the bolt and sensor.

      Note


      • The speed sensor is easily damaged.

        When pulling out the speed sensor from the axle hub, do not use excessive force to rotate and remove it.

      • Prevent foreign matter from attaching to the sensor tip.

      • Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.