BRAKE PEDAL SUPPORT(for LHD) INSTALLATION

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY


    1. A000Y19E01
      Text in Illustration
      *1 Brake Pedal Support

      Install the brake pedal support with the 2 bolts.

      Torque:
      19 N*m  { 195 kgf*cm, 14 ft.*lbf }

    2. Install the 4 nuts.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

  2. INSTALL PUSH ROD PIN


    1. A000ZDTE01
      Text in Illustration
      *1 Push Rod Pin
      *2 Clip
      *3 Push Rod Clevis
      *4 Lithium soap base glycol grease

      Apply a light coat of lithium soap base glycol grease to the push rod pin.

    2. Set the master cylinder push rod clevis in place, insert the push rod pin from outside of the vehicle and then install a new clip.

  3. INSTALL BRAKE PEDAL RETURN SPRING


    1. Install the spring between the pedal and steering column.

  4. CONNECT CONNECTORS


    1. Connect the stop light switch connector and then attach the wire harness clamp.

    2. Connect the brake pedal stroke sensor connector.

  5. CHECK BRAKE DRAG

  6. CHECK AND ADJUST BRAKE PEDAL

    Click here

  7. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  10. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  11. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  12. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  13. CHECK SRS WARNING LIGHT

    Click here