FRONT UPPER SUSPENSION ARM REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE BATTERY SERVICE HOLE COVER LH

   Click here

2. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. REMOVE FRONT WHEEL

5. REMOVE FRONT AXLE SHAFT NUT LH

   Click here

6. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

   Click here

7. REMOVE FRONT DISC

   Click here

8. REMOVE FRONT DISC BRAKE DUST COVER LH

   Click here

9. DISCONNECT SKID CONTROL SENSOR WIRE

   Click here

10. REMOVE FRONT SPEED SENSOR LH

    Click here

11. DISCONNECT TIE ROD ASSEMBLY LH

    Click here

12. DISCONNECT FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH

    Click here

13. DISCONNECT FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH

    Click here

14. REMOVE STEERING KNUCKLE SUB-ASSEMBLY LH

    Click here

15. DISCONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

    Click here

16. REMOVE FRONT STABILIZER LINK ASSEMBLY LH

    Click here

17. REMOVE AIR CONNECTOR CLIP HOLDER

    Click here

18. DISCONNECT NO. 4 HEIGHT CONTROL TUBE

    Click here

19. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY

    Click here

20. REMOVE ENGINE ROOM SIDE COVER LH

    Click here

21. REMOVE FRONT SHOCK ABSORBER CAP LH

    Click here

22. REMOVE ABSORBER CONTROL ACTUATOR

    Click here

23. REMOVE FRONT PNEUMATIC SHOCK ABSORBER WITH CYLINDER ASSEMBLY LH

    Click here

24. REMOVE FRONT PNEUMATIC CYLINDER O-RING LH

    Click here

25. REMOVE INNER NO. 1 ARM ATTACHMENT PLATE LH

    
    

    1. 

       Remove the 3 bolts and inner No. 1 arm attachment plate LH.

26. REMOVE INNER NO. 2 ARM ATTACHMENT PLATE LH

    
    

    1. 

       Remove the 2 bolts and inner No. 2 arm attachment plate LH.

27. REMOVE FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH

    
    

    1. Remove the bolt and nut, and then remove the front No. 1 suspension upper arm assembly LH from the inner No. 1 arm attachment plate LH.

28. REMOVE FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH

    
    

    1. Remove the bolt and nut, and then remove the front No. 2 suspension upper arm assembly LH from the inner No. 2 arm attachment plate LH.