REAR ACTIVE STABILIZER CONTROL ECU INSTALLATION

PROCEDURE


  1. INSTALL BRACKET


    1. A000U06

      Install the bracket with the 4 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  2. INSTALL REAR ACTIVE STABILIZER CONTROL ECU


    1. A000ZATE01

      Connect the ECU connector.


      1. Connect the ECU connector. (*1)

      2. Rotate the lever in the direction of the arrow until a "click" sound is heard. (*2)

      3. Lock the lever's lock. (*3)

    2. Connect the shielded ground wire connector.

    3. A000W1J

      Install the ECU with the 2 bolts.

      Torque:
      14 N*m  { 138 kgf*cm, 10 ft.*lbf }

  3. CONNECT REAR ACTIVE STABILIZER CONTROL ACTUATOR CONNECTOR


    1. A000W6FE02

      Connect the actuator connector labeled A.

    2. Connect the actuator connector labeled B.


      1. Connect the actuator connector. (*1)

      2. Rotate the lever in the direction of the arrow until a "click" sound is heard. (*2)

      3. Lock the lever's lock. (*3)

  4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Click here

  5. INSTALL SERVICE PLUG GRIP

    Click here

  6. INSTALL BATTERY SERVICE HOLE COVER

    Click here

  7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  9. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  10. CHECK SRS WARNING LIGHT

    Click here