REAR ACTIVE STABILIZER CONTROL ECU REMOVAL

CAUTION / NOTICE / HINT

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

PROCEDURE

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
REMOVE BATTERY SERVICE HOLE COVER LH

Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE BATTERY SERVICE HOLE COVER

Click here
REMOVE SERVICE PLUG GRIP

Click here
REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

Click here
DISCONNECT REAR ACTIVE STABILIZER CONTROL ACTUATOR CONNECTOR
1. Detach the wire harness clamp.
2. Disconnect the actuator connector labeled A.
3. Disconnect the actuator connector labeled B.
  1. Release the lever's lock. (*1)
  2. Press the claw and move the lever in the direction of the arrow in the illustration. (*2)
  3. Disconnect the actuator connector. (*3)
    
    Note
    
    When disconnecting the actuator connector, do not apply excessive force to the wire harness.
REMOVE REAR ACTIVE STABILIZER CONTROL ECU
1. Remove the 2 bolts and ECU.
2. Disconnect the ECU connector.
  1. Release the lever's lock. (*1)
  2. Press the claw and move the lever in the direction of the arrow in the illustration. (*2)
  3. Disconnect the ECU connector. (*3)
    
    Note
    
    When disconnecting the ECU connector, do not apply excessive force to the wire harness.
3. Disconnect the shielded ground wire connector.
REMOVE BRACKET
1. Remove the 4 screws and bracket.