SUSPENSION CONTROL ECU(for RHD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL SUSPENSION CONTROL ECU


    1. A000V7Q

      Install the suspension control ECU to the bracket with the 2 nuts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note


      • Avoid any impact to the suspension control ECU.

      • Do not drop the ECU. If it is dropped, replace it with a new one.

  2. INSTALL SUSPENSION CONTROL ECU WITH BRACKET


    1. A000TXIE02
      *1 Network Gateway ECU

      w/ Driver Monitor Camera:

      Install the ECU with the 2 nuts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }
    2. A000WF8

      Install the ECU with bracket with the 2 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    3. A000TQ2

      Connect the connectors.

    4. w/ Driver Monitor Camera:

      Connect the driver monitor ECU connector.

    5. w/ Driver Monitor Camera:

      Connect the network gateway ECU connector.

  3. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  6. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  7. ADJUST VEHICLE HEIGHT

    Click here

    Note

    If the suspension control ECU has been replaced, be sure to adjust the vehicle height.

  8. CHECK SRS WARNING LIGHT

    Click here

  9. ADJUST HEADLIGHT ASSEMBLY

    Click here

  10. ADJUST OBJECT RECOGNITION CAMERA

    Click here