FRONT STABILIZER BAR INSPECTION

PROCEDURE


  1. INSPECT FRONT STABILIZER LINK ASSEMBLY


    1. A000V9F

      Flip the ball joint stud back and forth 5 times as shown in the illustration.

    2. Temporarily install the nut, and use a torque wrench to turn the nut continuously at a rate of 2 to 4 seconds per turn. Take the torque reading on the 5th turn.

      Standard turning torque
      1.96 N*m (20 kgf*cm, 17.3 in.*lbf) or less

      If the value is not within the specified range, replace the front stabilizer link assembly.

    3. Check the dust boot for cracks or grease leakage.