FRONT STABILIZER BAR REMOVAL

PROCEDURE


  1. REMOVE FRONT CENTER FLOOR COVER

    Click here

  2. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

    Click here

  4. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

    Click here

  5. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  6. REMOVE FRONT LOWER SUSPENSION MEMBER PROTECTOR

    Click here

  7. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


    1. A000UTH

      Remove the 2 nuts and front stabilizer link.

      Tech Tips

      If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

  8. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Remove the RH side following the same procedures as the LH side.

  9. REMOVE FRONT NO. 1 STABILIZER BRACKET LH

    A000TQS

    1. Remove the bolt and wire harness bracket.

    2. A000WNN

      Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front frame assembly.

  10. REMOVE FRONT NO. 1 STABILIZER BRACKET RH


    1. A000UH2

      Remove the bolt and disconnect the water with motor and bracket pump bracket.

    2. A000ZSZ

      Remove the 2 bolts and the front No. 1 stabilizer bracket RH from the front frame assembly.

  11. REMOVE FRONT STABILIZER BAR


    1. Remove the front stabilizer bar from the vehicle.

  12. REMOVE FRONT NO. 1 STABILIZER BAR BUSH


    1. Remove the 2 front No. 1 stabilizer bar bushes from the front stabilizer bar.