FRONT LOWER SUSPENSION ARM INSPECTION

PROCEDURE


  1. INSPECT FRONT NO. 2 SUSPENSION LOWER ARM

    A000XEF

    1. Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.

    2. Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the fifth turn.

      Standard turning torque
      3.0 N*m (30.6 kgf*cm, 26.6 in.*lbf)

      If the result is not as specified, replace the front No. 2 suspension lower arm.

    3. Check the dust boot for cracks or grease leakage.