FRONT ACTIVE STABILIZER CONTROL ACTUATOR REMOVAL

PROCEDURE


  1. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  2. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT CENTER FLOOR COVER

    Click here

  5. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  6. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

    Click here

  7. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

    Click here

  8. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  9. REMOVE FRONT LOWER SUSPENSION MEMBER PROTECTOR

    Click here

  10. REMOVE FRONT STABILIZER LINK ASSEMBLY LH

    A000UTH

    1. Remove the 2 nuts and front stabilizer link.

      Tech Tips

      If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

  11. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Remove the RH side following the same procedures as the LH side.

  12. REMOVE FRONT FENDER WHEEL OPENING MOULDING LH

    Click here

  13. REMOVE FRONT FENDER LINER LH

    Click here

  14. DISCONNECT FRONT ACTIVE STABILIZER CONTROL ACTUATOR CONNECTOR

    A000UC7E01

    1. Disconnect the wire harness clamp.

    2. Disconnect the actuator connector labeled A.

    3. Disconnect the actuator connector labeled B.


      1. Release the lever's lock. (*1)

      2. Press the claw and move the lever in the direction of the arrow in the illustration. (*2)

      3. Disconnect the actuator connector. (*3)

        Note

        When disconnecting the actuator connector, do not apply excessive force to the wire harness.

  15. REMOVE FRONT NO. 1 STABILIZER BRACKET LH

    A000ZM7

    1. Remove the bolt and wire harness bracket.

    2. A000WNN

      Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front frame assembly.

  16. REMOVE FRONT NO. 1 STABILIZER BRACKET RH


    1. A000YWH

      Remove the bolts and disconnect water with motor and bracket pump bracket.

    2. A000ZSZ

      Remove the 2 bolts and front No. 1 stabilizer bracket RH from the front frame assembly.

  17. REMOVE FRONT ACTIVE STABILIZER CONTROL ACTUATOR ASSEMBLY


    1. Remove the front active stabilizer control actuator from the vehicle.

  18. REMOVE FRONT NO. 1 STABILIZER BAR BUSH


    1. Remove the 2 front No. 1 stabilizer bar bushes from the front active stabilizer control actuator.