ACTIVE STABILIZER SUSPENSION SYSTEM DTC CHECK / CLEAR


  1. CHECK DTC


    1. Turn the power switch OFF.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the power switch ON (READY) and wait 30 seconds or more.

      Tech Tips

      As the power switch must be ON (READY) in order to detect certain DTCs, make sure the power switch is ON (READY).

    4. Turn the tester ON.

    5. Enter the following menus (Front active stabilizer):

      Select: Chassis / Front Stabilizer / DTC.

    6. Enter the following menus (Rear active stabilizer):

      Select: Chassis / Rear Stabilizer / DTC.

    7. Read the DTCs by following the prompts on the tester screen.

      Tech Tips

      Refer to the tester operator's manual for further details.

    8. Refer to the "DIAGNOSTIC TROUBLE CODE CHART" for DTC information Click here.

  2. CLEAR DTC


    1. Turn the power switch OFF.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the power switch ON (IG).

    4. Turn the tester ON.

    5. Enter the following menus (Front active stabilizer):

      Select: Chassis / Front Stabilizer / DTC.

    6. Enter the following menus (Rear active stabilizer):

      Select: Chassis / Rear Stabilizer / DTC.

    7. Clear DTCs.